Mechanical
From the Mechanical Engineering perspective we can effectively divide ourselves into two key areas – Office and site based works.
Office / Project Management
- Project Management and Contracting
- Design and Build Contracting
- Consultancy Services
- Site Surveys
- Feasibility studies
- Capital Plant Replacement
- Estimating / Tendering/Budget Costing
- Dilapidation Surveys
- Risk Assessments
- Cost Management
- CAD Drawings
- Snagging / Witnessing/Validation
- M&E Coordination
- Programming
- Collaborative Planning
- Commissioning
- Technical writing including O&M’s, Log Books and Asset Registers
- Energy Assessments
- Value Engineering
- Energy Performance Certificates
Design Services
- Supply and Extract Ventilation
- Displacement Ventilation
- Kitchen Extract Ventilation / UV Filtration
- Kitchen Extract Canopies and Ansul Fire Suppression
- Smoke Extract Vent (Natural and Mechanical)
- Swimming Pool Ventilation
- Natural Ventilation
- Heat recovery ventilation
- Air Handling Unit Design
- Packaged Plantroom Design
- Boiler room fit outs
- Automated Controls and BMS Systems
- Air and Ground Source Heat Pumps
- VRF / DX Air Conditioning
- LTHW / MTHW Heating
- Chilled Water and Chilled Beams
- Condenser Water Systems
- 4 Pipe Fan Coil Unit Design
- Hot and Cold Water Services
- Above Ground Drainage and Pumped Drainage
- Rain Water Harvesting
- Solar Heating
- Photovoltaics
- Compressed Air
- LPG and Natural Gas Piped Services
- Utility supplies
- Revit and BIM modelling
We are fully conversant with the following software:
- Autocad 2017 CAD package
- Bentley Hevacomp V25 Design Software
- Microsoft Project 2010
- Autocad 3D Revit
- BIM Modelling
